Ranked · 4 picks
Microphones that keep mechanical keyboard noise out of CS2 voice chat
Your team hears every keystroke because most gaming microphones are condensers, and a condenser is sensitive enough to pick up the whole room. A cardioid dynamic capsule changes the ratio between your voice and everything behind it. Four of them compared on connection, monitoring and what you still have to do with placement.
Published 15 November 2026 · Updated 15 November 2026Affiliate links
Compare the shortlist
| # | Photo | Model | Best for | Check first | Where to buy |
|---|---|---|---|---|---|
| 1 | Our pickAudio-Technica ATR2100x-USB | Players who want a dynamic USB microphone now and optional XLR use later. | End-address microphone needs a consistent speaking position | View on Amazon.comAdd to basket | |
| 2 | FIFINE AmpliGame AM8 | Players who want a dynamic microphone with USB convenience and optional XLR output. | RGB and onboard function controls are inactive in XLR mode | View on Amazon.comAdd to basket | |
| 3 | RØDE PodMic USB | Players who regularly record spoken content and want a dynamic microphone with USB and XLR. | Requires a suitable stand or arm and space near the speaking position | View on Amazon.comAdd to basket | |
| 4 | Samson Q2U Recording Pack | Players who want a dynamic desktop mic now and optional XLR use later. | Older stock and revised connector versions may differ; inspect the actual listing | View on Amazon.comAdd to basket |
Why your team hears your keyboard
Most microphones sold for gaming are condensers. The capsule is built to be sensitive, which is exactly right for recording a quiet voice and exactly wrong on a desk with a mechanical keyboard eighteen inches away. Everything that reaches it is captured: keystrokes, fans, the chair, the room.
A cardioid dynamic capsule is the usual answer. It is less sensitive by design, and its pickup pattern is directional, so it favours what is in front of it over what is beside and behind it. Combined, those two properties mean that when your mouth is close to the microphone, your voice sits well above the keyboard instead of alongside it.
It is a ratio, not a filter. No microphone removes a sound that reaches it. What you are buying is a better starting ratio, and then placement does the rest.
What to look for on the listing
- Type: cardioid dynamic. This is the single specification that matters here. If the listing says condenser, it will hear more of your desk.
- A headphone output on the microphone. It lets you hear yourself as your team hears you, which is how you find out that the keyboard is loud in the first place.
- USB now, XLR later. A microphone with both connectors works over USB today and still has somewhere to go if you ever add an interface. It costs nothing extra to keep that door open.
- How it mounts. A boom arm clamped to the same desk as the keyboard carries keystrokes up the stand as vibration. A shock mount, or clamping to a different surface, is part of the purchase rather than an accessory to postpone.
Placement does the other half
Get the capsule close — a hand’s width from your mouth rather than behind the monitor. Halving that distance raises your voice relative to anything further away by more than any setting will.
Then point it so the keyboard sits behind the capsule rather than in front of it. On an end-address microphone like the PodMic you speak into the end; on a side-address one you speak into the face. Getting that backwards is the most common reason a good dynamic still sounds distant, and it costs nothing to check.
Or make the keyboard quieter
The other half of the problem is the keyboard, and sometimes that is the cheaper fix. Linear switches are quieter than clicky ones, a board with internal dampening quieter again, and o-rings on the keycaps take the edge off the bottom-out. If you are replacing the board anyway, the keyboard buying guide covers switch types, and the layout comparison covers the sizes.
If you only need team chat and nothing else, compare a headset against IEMs before adding a desk microphone at all — a headset boom is already close to your mouth, which is most of what this page is about. For the wider selection, see the USB microphone guide and all audio choices.
These selections are based on published specifications, in particular the capsule type and connections stated by each manufacturer. They are not our own noise-rejection recordings, and the amount of keyboard your team hears will depend on your room, your desk and where you put the microphone.
Audio-Technica ATR2100x-USB
Audio-Technica
ATR2100x-USB is a sensible format when a separate voice microphone should also work with a future recording interface. Start with USB if your PC only needs a straightforward input; an XLR cable alone does not create a computer connection.
- Type
- Cardioid dynamic
- Outputs
- USB-C / XLR
- Monitoring
- 3.5 mm headphones
- USB-C and analogue XLR outputs
- Headphone output for direct monitoring
End-address microphone needs a consistent speaking position
FIFINE AmpliGame AM8
FIFINE
AM8 is worth comparing when you need a separate mic without committing to an audio interface immediately. Use USB for the initial setup and add XLR only when there is a specific mixer or interface you intend to use.
- Type
- Cardioid dynamic
- Outputs
- USB / XLR
- Monitoring
- USB mode
- USB and XLR connection routes
- USB mode supplies monitoring and gain controls
RGB and onboard function controls are inactive in XLR mode
RØDE PodMic USB
RØDE
PodMic USB belongs on the shortlist if voice recording is a recurring task rather than an occasional team call. Its USB path can avoid buying an interface, while XLR supports a separate recording chain later.
- Type
- Cardioid dynamic
- Outputs
- USB-C / XLR
- Address
- End-address
- USB and XLR outputs
- USB path includes DSP and direct headphone monitoring
Requires a suitable stand or arm and space near the speaking position
Samson Q2U Recording Pack
Samson
A dynamic microphone option with both USB and XLR outputs, suitable if you want to start directly on a PC and retain an interface upgrade path. Check the exact package and connector revision before ordering.
- Type
- Cardioid dynamic
- Connection
- USB / XLR
- Monitoring
- 3.5 mm headphone output
- USB and XLR output options
- Headphone monitoring output and included desktop accessories
Older stock and revised connector versions may differ; inspect the actual listing
FAQ
Frequently asked
Is there a microphone that does not pick up keyboard noise at all?
No. Every microphone picks up every sound that reaches it. What changes between models is the ratio: a cardioid dynamic capsule is less sensitive than a condenser, so when your mouth is close to it, your voice sits far above the keyboard rather than next to it. Choosing a dynamic improves that ratio, it does not create silence.
Why does a condenser pick up so much more?
A condenser capsule is built to be sensitive, which is what makes it good for recording a quiet voice or an instrument. On a gaming desk that sensitivity works against you: the keyboard, the case fans and the room arrive along with your voice. The capsule type is listed on each product page here.
Will a noise gate fix it instead?
Partly, and at a cost. A gate cuts everything below a threshold, so it removes keyboard clatter between sentences but not the clatter underneath your voice, and setting it aggressively means the first word of each call gets swallowed or you end up raising your voice to open it. It works better as a finishing touch on a microphone that is already close and directional.
Does placement matter more than the model?
Often, yes. Halving the distance between your mouth and the capsule raises your voice relative to anything further away, which no amount of processing matches. Putting the microphone on an arm clamped to the desk also lets keystrokes travel up the stand, so a shock mount or clamping to something other than the keyboard surface is part of the fix.
Should I just buy a quieter keyboard?
It is a fair answer to the same problem, and sometimes the cheaper one if you already own a microphone. Linear switches, a board with sound dampening, or o-rings on the keycaps all lower what the microphone has to reject in the first place.



